×

Yoors


Inloggen
Registreren
×

Yoors










notifications_noneadd
26-05-2019 14:09
1 volger , 1 antwoord
camera_alt
Afbeelding toevoegen
how to tie a tie

how to tie a tie


Although clip-on ties may seem like the easiest route, hand-tied straight ties are the most attractive option. Unsure how to tie a tie? Follow these easy step-by-step instructions on how to tie different knots

How to tie a tie windsor?

  • Drape the necktie around your collar with the wide end on your right hanging down to your thigh and the thin end on the left at about your rib cage.
  • Cross the wide end in front of the thin end from right to left, making an X-shape below your chin.

  • Loop the wide end of the tie horizontally around and behind the thin end.

  • Take the wide end over from the top and through the opening of the X and pull tight.

  • Hold the wide end with your right hand and wrap it in front over the thin end, from your right to your left.

  • Keeping the triangle intact with your left hand, bring the wide end towards your chest and from behind the loop, pass it over the X.

  • Using the index finger of your left hand, open up the triangle that has now formed over the X and pull the wide end all the way through.

  • To adjust the length, pull the knot up towards your collar while pulling the thin end of the tie down.

  • You may need to adjust the horizontal loop to make sure it’s flat and even.

How to tie a tie double windsor?

  • Fold the shirt collar up, undo the top button and place the necktie around your neck.
  • Ensure that the wide end of the tiw is 6-7 inches below than the narrow end and cross it over the narrow end.

  • Slip the tie through the gap between the neck and the tie knot.

  • Keep pulling the tie all the way around until it is back behind the narrow end of the tie.

  • Repeat step 2 with the other side.

  • After this, wrap the wide end of the tie and bring it back over towards the front.

  • Pull the wide end again through the gap between your neck and the knot loosely, so that a loop is created.

  • Slip the wide end of the knot through this newly created loop.

  • Adjust and tighten to neaten the knot and place your collar back down over the necktie.

How to tie a tie quick?

  • Drape the tie around your collar with the seam facing inward and the thick end on your left, two or three inches lower than your desired finishing position.
  • Bring the thick end horizontally across the front of the narrow end, and then pass it back horizontally behind the narrow end.

  • Pass the thick end again across the front of the knot from left to right.

  • Now pass the thick end again behind the knot horizontally from right to left.

  • Pass the thick end again across the front of the knot from left to right.

  • Slip a finger under this third horizontal loop.

  • Bring the tip of the thick end up underneath the loop around your collar and feed it up behind the knot, down over the front of the knot and through that third horizontal loop.

  • Pull the thick end through the horizontal loop and snug it down.

  • Adjust the tie by holding the knot in one hand and pulling gently on the narrow end with the other.

How to tie a tie easy?

How tie a tie over your hand?

  • Hang the tie over your hand with the wide side facing you and the narrow side opposite.
  • Wrap the narrow end around your hand. Think of this as "Wrap 1".
  • Wrap the narrow end around again. Call this "Wrap 2".
  • You now have two and a half "turns" or "wraps" in total. Pinch them with your other hand and slide them off of your hand.
  • Pinch the hanging ends close to the wraps with your starting hand. Here's where the tricky stuff happens. You're going to pass wrap 1 through wrap 2.
  • Then pass it back over the other two strands of the tie.
  • Once this is done, start pulling Wrap 2 upwards to tighten the knot.



expand_less

Meest gestemde posts



expand_less

Recente posts



expand_less

Volgers



expand_less

Collecties